All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
SoftEther help
After reading the old SoftEther thread, I thought I'd give it a try. I am trying to conect via L2TP/IPSEC from the phone.
I get a failure of the negotiation of the auth
message on the phone side. On the server logs I see this:
2015-03-16 22:36:16.538 Session "SID-MOBI2-[L2TP]-7": The parameter has been set. Max number of TCP connections: 1, Use of encryption: Yes, Use of compression: No, Use of Half duplex communication: No, Timeout: 20 seconds.
2015-03-16 22:36:16.538 Session "SID-MOBI2-[L2TP]-7": VPN Client details: (Client product name: "L2TP VPN Client", Client version: 408, Client build number: 9449, Server product name: "SoftEther VPN Server (32 bit) (Open Source)", Server version: 408, Server build number: 9449, Client OS name: "L2TP VPN Client", Client OS version: "-", Client product ID: "-", Client host name: "anonymous", Client IP address: "109.xxx.xxx.xxx", Client port number: 1701, Server host name: "100.xxx.xxx.xxx", Server IP address: "100..xxx.xxx.xxx", Server port number: 1701, Proxy host name: "", Proxy IP address: "0.0.0.0", Proxy port number: 0, Virtual Hub name: "VPN", Client unique ID: "465D0631C3704B548ABxxxx")
2015-03-16 22:36:28.690 Session "SID-MOBI2-[L2TP]-7": The session has been terminated. The statistical information is as follows: Total outgoing data size: 0 bytes, Total incoming data size: 1320 bytes.
Any idea what the problem could be? Given the above and my minimal experience with VPN setups, I'm out of clues
Comments
Solved it, I had to enable
Secure NAT
:Or install dnsmasq. Better than SecureNAT
Thanks! I'll monitor the CPU usage with SecureNAT and if it turns problematic, I'll look into it (have no idea how to set it up with the vpn at this point).
@deadbeef You can try referring this for debian based setup. It's not complete and I lack the time right now but it might help.
This is fantastic, many thanks!
@Nomad
Are you able to get it to work on pure IPv6 only server?
This question is for Local Bridge setup.
@Chuck, I don't know... Since I don't have native IPv6 connection I can't test it. Plus if it were to work, not having IPv4 you can't enter to many sites.
But it works with Nat IPv4, IPv4 + Tunneled IPv6 and IPv4 + native IPv6.