All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
OpenVZ on Xen VPS with single ip
I want to install OpenVZ as a test on a Xen cloud VPS from Rackspace. The problem is, I get only 1 address both of ipv6 and and ipv4, and I don't know how to get that setup working, since I am practically the biggest noob here when it comes to setting up a virtualization node.
I was first trying to get this up and running on KVM due to the far better performance, but due to the lack of economical plans for the same, I am trying to do this from a Xen server now.
I want to access this server from the internet, not just a private network, so I do need to have something assigned to it. I am fine with assigning just a port range though. So any ideas how I could go about doing this? Any help would be colossally appreciated.
Comments
I've never done this, but I assume you would assign the OpenVZ a private IP on a virtual interface and run NAT to the ports you want the OpenVZ VPS to serve on the public facing IP. I mean I've done it with LXC but never with OpenVZ, and never under Xen.
Did that already, but it sucks that I can't even ping the outside world, and I have to connect to my Xen VPS via VNC just to use the terminal in there to ssh to the VPSes. (Yes, I'm too much of a noob to setup a VPN, especially after OpenVPN removed easy-rsa from the default library). I do have a /64 lying around, any ideas on how I could use some addresses from there instead?
Actually yeah you could add a good old IPv6 tunnel and dedicate those addresses. My assumption is that Xen wouldn't hold you back any on that route. A few config options to make sure you don't forget, if you're like me and always forget the simplest thing.
http://openvz.org/IPv6
Thanks, that is some really useful information. Any ideas on how to tunnel addresses from another VPS? In a different continent altogether?
I think a GRE tunnel would be about as effective as anything. BuyVM has a guide that is usually used for their DDOS protected IPs, but it's pretty much just picking your ports. Let me know if you have any luck, a little interested now.
http://wiki.frantech.ca/doku.php/gre_tunnel
It works for me currently with ipv4 added via a local interface(natively). Trying out ipv6 soon.