New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
PPTP setup with CSF on OpenVZ
I have checked alot about resolving the issue with the PPTP on OpenVZ and CSF installed but could not get a solution as of yet.
After setting up everything , i can connect the VPN but no data goes through and it shows no internet connectivity.
I use Venet0 in place of eth0 as its a openVZ.
Has any one come with the same issue? if yes , could please perhaps guide me in the correct direction to solve it? i will be very thankful
Comments
Did you try disabling CSF to make sure it is working correctly to start with?
If it's still not working make sure you aren't having the same problem I did: http://lowendtalk.com/discussion/comment/218906/#Comment_218906
I did disable it , and it still remains the same , no internet connectivity
http://www.lowendtalk.com/discussion/8385/vpn-help-pptp-on-openvz
try that
Do you sure PPTP module is active? Setting?
Make sure PPP is working.
yum install ppp pppd
You should see gibberish similar to the following
~�}#�!}!}!} }4}"}&} } } } }%}&)Q�}4}'}"}(}"p})
which will continue for about 30seconds then return to command prompt. If not contact your provider and get them to enable PPP on the node and give your container access.
yep its working.
Edit the sysctl file:
nano /etc/sysctl.conf
Find the “net.ipv4.ip_forward” and uncomment it by removing the “#”:
net.ipv4.ip_forward=1
If still nothing see this:
http://www.putdispenserhere.com/pptp-vpn-setup-guide-for-a-debian-openvz-vps/
thanks , its already uncommented