New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Hetzner Network Config
I installed Windows 2012 through the rescue system using qemu. I configured Windows through vnc and set the network settings using the information in Hetzner Robot. I made sure remote desktop was enabled. The issue is the network status says "no internet" and I can't connect using RDP. I can only connect using VNC and the internet is only active using DHCP. Any ideas I can try?
Comments
Did you install the correct network drivers?
I did not check that.
Err yes. It is since everything is kinda saved on the "rescue" portion of disk/memory?
I didn't think that through. I got it working...thank you!
Thank you for using our ticketing system. Please rate our support's performance.