New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Got a problem using Nyrs OpenVPN script
Any ideas why OpenSSL wont work?
I'm using a fresh CentOS 6 minimal install (64 bit) on a NAT VPS.
But when I try to run Nyrs OVPN script I'm getting the following error:
wget https://git.io/vpn -O openvpn-install.sh && bash openvpn-install.sh
--2016-12-09 14:48:59-- https://git.io/vpn
Resolving git.io... 54.243.91.166, 54.243.89.142, 54.225.223.184, ...Connecting to git.io|54.243.91.166|:443... connected.
OpenSSL: error:14077438:SSL routines:SSL23_GET_SERVER_HELLO:tlsv1 alert internal error
Unable to establish SSL connection.
The file "openvpn-install.sh" then does exist but when I chmod +x and run it nothing happens when I ./openvpn-install.sh
Comments
Try the direct link to github instead ? :
https://github.com/Nyr/openvpn-install/raw/master/openvpn-install.sh
IF that works, you could upgrade to a high security fork of nyr's script by angristan.
It has lots more nice options: https://github.com/Angristan/OpenVPN-install
It did work thanks! But now I created a test openvpn cert and connected to it (So OVPN GUI says connected) but I dont have internet access even though I set DNS as Google DNS in my network conf and used my correct Port range (I sent my host a ticket to make sure it is within my port range) + I used the public shared ipv4 adress on setup. I've used Nyrs script many times and never had a problem so no idea why it does not work now
I think though that this time something with the vps cou ld be the problem as ovpn does connect to the conf loaded but I have no inet access. Do I need to portforward my own PC if ovpn port is 101xx?
This ^
I've run Nyrs script on many NAT vps without problem from LES range inceptionhosting.
I do get a public (shared) IPv4 adress with 20 forwarded ports to use so it should work.
FIXED
Tun/tap enabled?
Fixed it already with Nyrs help
BTW, where's Nyr? His webpage is gone, too...
Contacted him on github
It'd be nice if you share how you fixed it, so other people search for the same issue will benefit from this.
Ignore certification in wget
a reference...might help https://github.com/Nyr/openvpn-install/issues/240
This is probably one of the instances where one must not ignore.
I always entered public ip during setup first as I followed some tutorial from my host. However one would need to enter the (internal) NAT ip first and after port etc has been asked it would ask for the public ip.