New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
GRE Tunnel - Not Reachable
I've been following the BuyVM guide on how to setup a GRE Tunnel for my Ramnode VPS and my dedicated server.
But for some reason, when I ping either address:
ping 192.168.168.1
PING 192.168.168.1 (192.168.0.1) 56(84) bytes of data.
From 199.x.x.x icmp_seq=1 Destination Host Unreachable
Anyone have a solution? I've rebooted and run the commands each end a dozen times at this point.
Comments
ip link show
I thought this would be a thread about you
and not some stupid GRE.
i will admit aswell, i came here expecting a story, but i leave disappointed.
and not some stupid GRE.
Yeah, Keepass keeps inputting my Username to Thread names.
Filtered IP (Ramnode)
gre1: <POINTOPOINT,NOARP,UP,LOWER_UP> mtu 1476 qdisc noqueue state UNKNOWN mode DEFAULTlink/gre "Filtered_IP" peer "Destination_IP"
Destination:
gre1: <POINTOPOINT,NOARP,UP,LOWER_UP> mtu 1476 qdisc noqueue state UNKNOWN mode DEFAULT
link/gre "Destination_IP" peer "Filtered_IP"
It appears I found the root cause. After I ticketed Ramnode to allow for GRE Functionality, it must've been lost somehow.