SolusVM Help

hostrerum

Hello guys.

As im playing with virtualisation in order to gain knowledge.
I need someone to help me who can teach me how to install and configure both SolusVM Master and slave.

Currently,i installed SolusVM master on my VPS and Slave on my Dedicated but there is some issue which is causing it not to run and create virtual servers.

P.S: Im looking to pay for this but not much.

I just want to learn how to install and configure SolusVM

Thanks

rsk

What sort of issues?

http://docs.solusvm.com/ is a good resource to be honest. Everything can be done by reading from there.

hostrerum

@rsk said:
What sort of issues?

http://docs.solusvm.com/ is a good resource to be honest. Everything can be done by reading from there.

Thanks for commenting mate.
Once i have added my slave to the node list , It doesnt show the resources and IPS of the server.
IM kinda new to this so if you could help

Thanks

lankapartnerhost

Did you add IP blocks ? & did node settings ?

hostrerum

@lankapartnerhost said:
Did you add IP blocks ? & did node settings ?

Thats where im stuck.

Thanks

rsk

@fraghostsolutions said:

@fraghostsolutions just get the IP block details from your dedicated server provider.

They should give you it in this format 1.1.1.0/25 (if you purchased a block)

Then it means

Network: 1.1.1.0

Mask: 255.255.255.128 (which is a /25)

Gateway: the gateway IP should also be given to you by your provider It usually is the first or the last IP in the block (so in our case either 1.1.1.1 or 1.1.1.254)

After you add the block

Add IPs to that block. (if you had 1.1.1.0/25 and the gateway was 1.1.1.1)

Your range of usable IPs would be 1.1.1.2 upto 1.1.1.126

anyNode

Off topic, but consider using Proxmox as an alternative to SolusVM

jar

Sounds like the master's ip isn't in the slaves allow list.

MonsteR

Hi,
I can help you with this for free if you have went through all the solusvm docs, Add me on skype if you like at RaptorNode