New on LowEndTalk? Please Register and read our Community Rules.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
All new Registrations are manually reviewed and approved, so a short delay after registration may occur before your account becomes active.
Debian 10 VM not showing last 4, 5 lines in Hyper-V
I just installed Debian 10 on Hyper-V (Windows 10). I noticed that last 4, 5 lines are cut off and not shown on screen. So let's say if I type ok
then it is not shown on screen and when I press enter then it won't show error command not found
because both are actually 4, 5 lines below. Then I press enter 4, 5 times and then it will start showing that ok
along with error message. So basically cursor is 4, 5 lines below and is not shown on screen.
Whether I run it in full screen or window it has same behaviour. Any idea how to fix it?
Comments
Try
reset
andresize
reset
orclear
fixes the issue temporarily as cursor moves to the top. But once it goes to the bottom, same problem.resize
command not found.Install xterm: https://manpages.debian.org/testing/xterm/resize.1.en.html
This is a nice post